Are there any other heat treatment methods for SPA-H steel plates besides annealing?

Dec 25, 2025 Leave a message

Besides annealing, SPA-H steel plates can be subjected to several other heat treatment methods, though most are not standard practices-they are used only for specific performance requirements or processing needs. Below are the key alternative heat treatment methods, their purposes, and application scenarios:

info-222-169

1. Normalizing

Process Principle: Heat the steel plate to 880–920°C (above the upper critical temperature of ferrite-pearlite steel), hold it for a sufficient time to achieve uniform austenitization, then cool it in still air at room temperature.

Effect on Properties:

Refines the ferrite-pearlite microstructure, eliminating banded structures or coarse grains caused by uneven hot rolling.

Improves strength and toughness balance (tensile strength increases by 5–10%, impact toughness rises by 15–20% compared to as-rolled state).

Reduces internal stress more effectively than as-rolled cooling, enhancing dimensional stability for large structural components.

Application Scenarios: Suitable for thick SPA-H plates (>20 mm) used in load-bearing structures (e.g., bridge components, container frames) where high toughness and structural uniformity are required.

info-232-220

2. Stress Relief Annealing (Low-Temperature Annealing)

Process Principle: Heat the steel plate to a low temperature of 550–650°C (below the critical transformation temperature), hold for 1–2 hours per 25 mm thickness, then cool slowly.

Effect on Properties:

Eliminates residual internal stress caused by cold working (e.g., bending, cutting) or welding, without changing the original microstructure or strength.

Prevents deformation or cracking of SPA-H components during subsequent outdoor use (especially in temperature-fluctuating environments).

Application Scenarios: Mandatory for welded SPA-H signs, guardrails, or planters to avoid stress corrosion; also used after cold bending of cold-rolled SPA-H strips.

info-229-215

3. Quenching and Tempering (Q&T) – Rarely Used for SPA-H

Process Principle: A two-step process:

Quenching: Heat to 850–900°C, hold, then cool rapidly in water or oil to form martensite.

Tempering: Reheat to 400–600°C, hold, then cool to transform martensite into tempered sorbite.

Effect on Properties: Significantly improves tensile strength (up to 600–700 MPa) and hardness, while maintaining good toughness.

Limitations & Notes:

SPA-H is a low-alloy weathering steel, not designed for quenching and tempering-excessive alloying elements (Cu, Cr, Ni) are insufficient to stabilize martensite fully, leading to uneven performance.

The process increases production costs and may reduce the patina-forming ability of the steel surface (due to microstructure changes).

Application Scenarios: Only used for special SPA-H components requiring ultra-high strength (e.g., heavy-duty mechanical parts in corrosive environments).

info-231-219

4. Patina Accelerating Heat Treatment (Functional Heat Treatment)

Process Principle: Heat the steel plate to 300–400°C in a humid, oxygen-rich environment, hold for several hours, then cool naturally.

Effect on Properties: Accelerates the migration of surface alloy elements (Cu, Cr, Ni), promoting the rapid formation of a dense, uniform patina layer (shortens natural patina time from 6–12 months to 2–4 weeks).

Application Scenarios: Used for SPA-H decorative panels or signs that need to achieve a consistent rust aesthetic quickly, without affecting the steel's mechanical properties.

info-233-226