Corten steel's core anti-corrosion mechanism relies on the formation of a dense protective rust layer, and surface dust will not penetrate or damage this rust layer. In outdoor environments, natural rainfall can usually wash away most of the loose dust, without affecting the material's corrosion resistance or structural stability.
Excessive or frequent cleaning (such as using high-pressure water guns or chemical detergents) may instead damage the fragile initial rust layer (within the first 1–2 years of installation) or disrupt the uniform distribution of the mature rust layer, reducing its protective effect.

Dust accumulation in enclosed/less rainy areas: For pergolas installed in enclosed courtyards, covered terraces, or arid regions with little rainfall, dust and debris may accumulate on the surface for a long time, covering parts of the steel and leading to uneven rust formation (local areas may appear dull or discolored). In this case, it is advisable to wipe the surface with a soft dry cloth or rinse with low-pressure water every 3–6 months to remove accumulated dust.
Adhesion of corrosive substances: If the pergola is near roads, construction sites, or industrial areas, dust may mix with pollutants (such as oil stains, cement dust, or acidic particles). This mixed dirt may cause localized corrosion if left for a long time. It is necessary to clean the contaminated areas in a timely manner with clean water (avoiding acidic/alkaline cleaners) and dry the surface afterward.
Aesthetic maintenance needs: If the owner pursues a neat and uniform rust color appearance, occasional dust removal can keep the surface rust layer showing a consistent reddish-brown tone, enhancing the decorative effect of the pergola.

Avoid harsh tools/agents: Do not use steel wool, wire brushes, or abrasive cleaners, as they will scratch the rust layer; do not use acidic or alkaline detergents that can react with the rust layer and damage its protective structure.
Control water pressure: If using water for cleaning, choose low-pressure rinsing (pressure <50 bar) instead of high-pressure water guns to prevent the rust layer from being washed off.
Natural drying: After cleaning, let the surface dry naturally in a ventilated environment, and do not wipe it with a hard cloth to avoid damaging the rust layer.









