SPA‑C is produced by cold rolling, so it has a much smoother, cleaner, and more uniform surface than hot‑rolled SPA‑H.
It offers excellent thickness precision and flatness, which is critical for thin‑gauge forming and appearance parts.
Cold rolling and subsequent annealing give SPA‑C superior ductility and formability compared to SPA‑H.
It is easier to bend, stamp, deep draw, and roll-form, making it suitable for complex thin parts.

SPA‑H (hot‑rolled) has higher yield and tensile strength and is designed for structural load‑bearing applications.
Cold‑rolled SPA‑C has lower yield strength but better plasticity, so it is not intended for heavy structural use.
Cold rolling allows production of thin‑gauge products: typically 0.6–2.3 mm.
SPA‑H is hot‑rolled, with a much wider and thicker range: approximately 1.5–40 mm.

Cold rolling refines the microstructure and improves homogeneity, leading to more consistent mechanical properties across the sheet.
Hot‑rolled SPA‑H has a coarser microstructure typical of hot‑finished steel.
The smoother, cleaner surface of SPA‑C allows more uniform and even patina development in the early stages.
SPA‑H has a rougher surface, but both grades eventually form a stable, protective rust layer.
SPA‑C: thin exterior panels, enclosures, formed parts, decorative components.
SPA‑H: bridges, railway cars, containers, structural steel, heavy machinery.








