Max Allowable Thickness for ASTM A588 Cold Forming?

Dec 29, 2025 Leave a message

Max Allowable Thickness for ASTM A588 Cold Forming?

A key question for foreign customers using ASTM A588 Corten Steel in cold forming processes (bending, stamping, rolling) is: What's the maximum thickness that avoids cracking or performance degradation? The core answer is 8mm for general cold forming; up to 12mm with strict process control. This article clarifies influencing factors and practical guidelines.

 

info-1182-1182

 

1. General Maximum Allowable Thickness

Per ASTM A588 standard and industry practice: - For common cold forming operations (e.g., bending with inner radius ≥ 3×sheet thickness), the maximum safe thickness is 8mm. Below this thickness, ASTM A588's inherent ductility (elongation ≥ 20%) ensures forming without cracking or reducing yield/tensile strength. - Thicknesses above 8mm increase forming difficulty. Beyond 12mm, cold forming is not recommended-even with optimized processes, the risk of edge cracking or residual stress-induced performance degradation rises sharply.

 

info-1706-1279

 

2. Key Factors Affecting Allowable Thickness

Subgrade (Grade A vs Grade K): Grade K (with Nb/V grain refiners) has better cold formability than Grade A. For Grade K, the maximum allowable thickness can be extended to 12mm under strict process control; Grade A is limited to 8mm to avoid cracking.

Forming Severity: Gentle forming (e.g., large bending radius ≥ 5×thickness) allows thicker sheets (up to 12mm). Severe forming (e.g., small radius < 2×thickness) reduces the maximum thickness to 6mm, as excessive plastic deformation causes microcracks.

Edge Condition: Unprocessed, rough edges (from shearing) are prone to cracking during forming. For sheets ≥ 6mm, edge grinding (to remove burrs and sharp edges) is mandatory to increase allowable thickness.

 

info-1542-1238

 

3. Practical Cold Forming Recommendations

Thickness ≤ 8mm (Grade A/K): No special process adjustments needed. Use standard cold forming equipment; ensure bending radius ≥ 3×thickness for Grade A and ≥ 2.5×thickness for Grade K.

Thickness 8-12mm (only Grade K): ① Adopt slow forming speed to reduce residual stress; ② Increase bending radius to ≥ 4×thickness; ③ Pre-heat slightly (≤ 150℃, not exceeding the standard's cold forming definition) to improve ductility; ④ Conduct post-forming inspection for cracks via penetrant testing (PT).

Thickness > 12mm: Avoid cold forming. Opt for hot forming (200-300℃) or use thicker sheets with subsequent machining to achieve the desired shape, preventing performance degradation.

 

info-1706-1279

 

In summary, ASTM A588's maximum allowable cold forming thickness is 8mm for general use, extendable to 12mm for Grade K with strict controls. Selecting the right subgrade and optimizing forming parameters ensures crack-free results and maintains the material's mechanical/weather-resistant properties.